Elite access systems Miracle-One Owner's Manual

OWNER’S MANUALTHE MIRACLE-ONE™ IS FOR USE ON VEHICULAR PASSAGE GATES ONLY AND NOT INTENDED FOR USE ON PEDESTRIAN PASSAGE GATES. MIRACLE-ONE™VEHICULAR

8INSTALLATION SETUPSInstallation40-50399A 40-50399A40-50399AMaster/Second OperatorsSingle OperatorWater Tight Conduit (Not provided)Shielded low volta

Gate in Open PositionGate in Closed Position90° / 105°8.5"7.75"25.75"This Plate Not Supplied 6"6"Miracle-One™ in Open Positio

10MOUNTING OPERATOR THAT OPENS TO THE INSIDE10.25"90° / 105°8.5"6"7.75"25.75"Miracle-One™ in Closed PositionMiracle-One™ in

11If using a gate crossbar, weld bar across all pickets. Do not weld the crossbar on just a few pickets, or they could bend.Make sure that the operato

12MOUNTING OPERATOR (CONTINUED)Position the Miracle-One™ horizontally level on the closed gate, where desired. For strength purposes, the front steel

13MOUNTING OPERATOR (CONTINUED)MOUNTING CONTROL BOXAfter permanently mounting operator back on brackets, lock the operator by turning the key to the v

ShieldGreenGreenBlueBrownRedWhiteBlackBlueBrownRedWhiteBlack14CONNECTING OPERATOR(S) TO CONTROL BOXSingle OperatorMaster/Second OperatorsMasterFlexibl

15CONTROL BOARDS DESCRIPTIONS1. Open or Close Relay LED2. Control Relay LED3. Motor Fuse (8 Amp Single) (15 Amp Master/Second)4. J1 Battery, Surge Sup

SURGE SUPPRESSOR CONNECTIONSMiracle-One™ Second Miracle-One™ MasterMiracle-One™ SingleBLACKMOTORWHITEREDBRAKESINGLE OR MASTER ONLY SECOND ONLYBROWNBLU

SURGE SUPPRESSOR CONNECTIONSGreen Ground WireRefer to Page 18Refer to Page 20Refer to Page 22Refer to Page 2424 Vdc Factory Installed Radio Receiver B

EARTH GROUND ROD INSTALLATIONTo reduce the risk of SEVERE INJURY or DEATH:• ANY maintenance to the operator or in the area near the operator MUS

21WIRING OPERATOR(S) TO CONTROL BOARD19Single ControllerWater tight conduit not provided from the second operator.To ENSURE proper operation of extern

20DC POWER CONNECTIONTo AVOID damaging 34 Vdc plug-in transformer, it MUST be enclosed in a suitable weatherproof enclosure and provided with proper w

Second ONLYREDBRAKEBROWNBLUELIMITSGREENCENTERLOOPBURGLARALARMINPUTUL SENSOR9101112 13 14 15 16 17 1821UL ALARM CONNECTIONBURGLAR ALARM CONNECTIONSThis

22Wiring at #21 and #22 will be recognized as an Open Only command, and Will Not close the gate. To automatically Close the gate after an open cycle,

24 VDC EXTERNAL LOOP DETECTOR WIRING2324 Vdc “Center” Loop Detector - Allows gate to stay open when vehicles are obstructing path. Caution: This optio

2624ENTRAPMENT PROTECTION DEVICENon-Contact Sensors (24 Vdc Photo Electric Sensors)NOTE: If multiple pairs of sensors are being used, all of the senso

25MAGLOCK OR SOLENOID CONNECTIONPart # AMG1300Part # 240MAURelay Contact Rating 0.5 Amp - 125 Vac2 Amp - 30 VdcSeparate Powerfor SolenoidSeparate Powe

26Inside PropertyInside PropertySETTING TIMERSET GATE OPENING DIRECTIONTo use the automatic close for the gate system, the timer should be switched to

27LIMIT SWITCH ADJUSTMENTSRemove operator cover and unlock the operator to adjust the gate’s traveling distance with the limit switches. Loosen the 2

31• BEFORE attempting to install, operate or maintain the operator, you must read and fully understand this manual and follow all safety instructions

28ADJUSTING REVERSE SENSORPOSITIVE STOP SETTINGThis switch is to be turned to YES when a Physical Stop is used to stop the gate(s). This can allow the

29315 MHZ RADIO RECEIVER PROGRAMMINGSetting Output Duration (M) or (C):P2Changing output duration from Momentary to Constant.The receiver is factory s

30CLOSE DELAY FOR OVERLAPPING GATESOverlap positioned on the Outside.Overlap positioned on the Inside.Overlap positioned on the Outside.Overlap positi

3331MAINTENANCE:1. Disconnect power before servicing.2. Severe or high cycle usage will require more frequent maintenance checks.3. Inspection and ser

32BUILT-IN RESET BUTTONAUDIO ALARMWhen the gate operator’s audio alarm (See below) has been tripped, the reset button must be pushed for the operator

33EMERGENCY MANUAL RELEASEStep 1: To move the gate during an emergency or power failure, insert key and turn counterclockwise to Unlock the operator f

34Probable Causes:1. Stuck remote control button.2. The radio receiver has malfunctioned in the “ON” position. Solutions:Unstick remote control butto

Check the FusesIf the gate is not moving in any direction be sure to check all of the LED displays on the control board. If the board power or chargin

36WIRING DIAGRAM • MIRACLE-ONE™ SINGLEBLACK MOTOR WHITE RED BRAKE SINGLE OR MASTER ONLY SECOND ONLY BROWN BLUE LIMITS GREEN BLACK MOTOR WHITE RED BRA

37WIRING DIAGRAM TABLE • MIRACLE-ONE™ SINGLEJ1J1J1J1J1J1J1J1J1J1J2J2J2J3J3J3J3J3J3J3J3J3J3J3J3J3J3J3J3J4J4J4J4J1J1J1J1J1J1J1 J2J2J2J2J2J2J3J3J3J3J4J4J

2CARTON INVENTORYUL AlarmBack Steel Mounting BracketFront Steel Mounting BracketOperator ArmFlexible Conduit with Attachment Fitting2 Keys34 Vdc 1.7 A

38WIRING DIAGRAM • MIRACLE-ONE™ MASTER/SECONDNOTE: See table on next page.

39WIRING DIAGRAM TABLE • MIRACLE-ONE™ MASTER/SECONDJ1J1J1J1J1J1J1J1J1J1J1J1J1J1J1J1J2J2J2J3J3J3J3J3J3J3J3J3J3J3J3J3J3J3J3J4J4J4J4J1J1J1J1J1J1J1 J2J2J2

40REPAIR PART ILLUSTRATIONSRepair PartsNOTE: See part names on next page.2 3 2 4 19 18 5 20 10 23 16 26 28 7 29 12 13 24 21 14 27 22 24 8 17 23 11 9 2

41REPAIR PART NAMES AND NUMBERSINDIVIDUAL PARTS ITEM PART# DESCRIPTION 2 Q162 1.5 Amp Fuse 3 Q222 Control Board (Single Operator) 4 Q223 Con

4224 Vdc External Loop DetectorsPage 23Part # A24(Sold Individually)Magnetic Locks (Outdoor)Page 25Part # MG1300Outdoor Siren with Strobe LightPart #

THREE YEAR LIMITED WARRANTYThe Chamberlain Group, Inc. (“Seller”) warrants to the first purchaser of this product, for the structure in which this pro

441. Owner and Installer must read all warnings and safety precautions. (Pages 4-7)2. Make sure control box is securely mounted. (Page 13)3. Operat

01-50593B ® 2011, The Chamberlain Group, Inc. - All Rights Reserved

3SPECIFICATIONSMechanical SpecificationsMotor – 24 Vdc, 12 Amps.Cycles – 100 / Day. (Consult factory for solar applications) Shipping Weight: Sing

6440-50399A 40-50399ANOTE: UL requires that all installations must have warning signs placed in plain view on both sides of the gate to warn pedestria

SAFETY INSTALLATION INFORMATION75 1. Vehicular gate systems provide convenience and security. Gate systems are comprised of many component parts. Th

6SUGGESTED ENTRAPMENT PROTECTION DEVICE LOCATIONSInside SafetyLoopInside PropertyOutside SafetyLoopInside SafetyLoopOutside PropertyInside PropertyOut

97SAFETY PRECAUTIONSOutside SafetyLoopCenterLoopInside SafetyLoopOutside PropertyInside PropertyOutssOutOutside SsidOutside StsidtsidOutsiOutsiOuOutOu